F0E1 Moderate Easy DIY

Amana Washer F0E1 — Suds Detected / Load Detection Fault

Amana Washer · Error code F0E1

What F0E1 Means

The control detected excessive suds or could not properly sense the load. Common when non-HE detergent or too much detergent is used.

Symptoms

  • F0E1 code
  • Extra rinse cycles added automatically
  • Long cycle time
  • Visible suds in the tub

Common Causes

1
Non-HE detergent used

Standard detergent creates excessive suds that the sensor reads as overflow risk.

2
Too much detergent

Even HE detergent creates suds if overdosed.

3
Clogged drain pump / slow drain

Slow rinse leaves residue that re-foams during agitation.

4
Faulty pressure sensor

Sensor misreads water level / foam height.

How to Fix It

  1. Run a Clean Washer / Affresh cycle with no detergent to rinse out residue.
  2. Switch to only HE-rated detergent; reduce dose by half on next cycle.
  3. Check drain pump and hose for partial clog.
  4. Inspect pressure sensor hose for kinks or moisture.
  5. Replace pressure sensor if calibration drift confirmed.

Parts You May Need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

Common replacement HE detergent View on Amazon→ Common replacement Pressure sensor View on Amazon→

More Amana Washer Codes

dL dL / dU — Door/Lid Lock Fault F02 F02 — Long drain / pump fault F1E1 F1E1 — Main Control Board Failure F21 F21 — Drain time too long F2E1 F2E1 — Stuck Key on User Interface F3E1 F3E1 — Pressure Switch / Water Level Sensor Fault

All Amana codes → All washer codes →

Verified against manufacturer documentation: amana.com

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician.